Thunder Laser Video
How to choose a reliable laser cutterWATCH NOW
Thunder Laser Video
How to install HR headWATCH NOW
Release Time：2017/01/12Browsing Times：2107
When you move laser head front and back, two couplings make a lot of noise. What is the cause of this? Both sides of transmission shaft are not aligned
Release Time：2017/01/11Browsing Times：2143
This problem is probably caused by one of three conditions: 1.Emergency Stop key is pressed in; 2.The fuse in power plug blew out or circuit breaker is off; 3.Defects of the Emergency Stop key or M...
Release Time：2017/01/09Browsing Times：2574
The Alarm prompt of LCD panel as follow： A.Frame/X/Y Slop over B.No enough extend space C.Water error D.Machine protected A.Frame/X/Y Slop over LCD panel shows the following information: Here are ...
Release Time：2017/01/07Browsing Times：2035
Remove: Turn off the whole machine power. 1.Unplug the wire between laser tube and laser power supply and take out from the hole(see pic) 2.unfix the tube. ① Cut the white ribbon ② Remove the screw...
Release Time：2017/01/05Browsing Times：2073
1.Please check before adjustment ①Hold and shake it to check if it becomes loose.(Can’t be wobble obviously) ②. In the back of X Axis Shaft have four rollers,both of them should locate on the rail....
Release Time：2016/12/21Browsing Times：2215
Please find a piece of 6mm acrylic (50*50mm),which used for testing the power of laser tube. Like below.
Release Time：2016/12/16Browsing Times：160
There are two solutions： 1.Unfix the X Axis. Turn off the whole machine power. There are four screws for each side，loosen them then you can fine tuning the angle of the X Axis. Shown as bellow. D...
Release Time：2016/12/13Browsing Times：1028
① X-axis Motor Screw A: There are four A screws, for fixing the X motor; Screw B: It’s for adjusting the belt tension, Please loosen the four A screws before adjust belt. How to adjust the belt of ...