How to add Reverse compensation setting in software
Release Time:2022/02/18 troubleshooting Browsing Times:659
Before you use the laser machine.
Please remove the transparent bag from the front of honey comb plate.
The transparent bag has a set of USB flash drive, and an engraving test sample. The USB
flash drive stores software, manuals, libraries, etc… that you will need.

Reverse Offset/Scan Offset compensation settings for this specific machine are included.
These settings needs to be entered into your RDWorks and/or LightBurn settings to
ensure the highest engraving quality.

For every laser machine, the setting is different. So please enter it to RDWorks/LightBurn
according to the card that came with the laser machine.
How to enter it in RDWorks/LightBurn
l In RDWorks
Please go to Config(s)>>System Setting>>Opitimize>>Scanning(Reverse compensation)>>Add,
then enter the Scan Offset compensation settings in>>OK.

Picture1

Picture2

Picture3
Please enter all the settings on the Card according to the steps.

Picture4
After that, just need to close this page, the settings will be store automatically.
l In Lightburn
Please go to Device setting>>Enable Scanning Offset Adjustment>>Add>> enter the settings>>OK.

Picture 1

Picture 2

Picture 3

Picture 4
After that, select to “OK”, the settings will be store.
- Warning of LCD panel
- How to replace laser tube?
- My door is too narrow (only 80CM wide), ho...
- Why does the cutting and engraving graphic...
- Laser cutter has a poor engraving quality/...
- The laser won’t turn on
- How to adjust the verticality between the ...
- How to judge if the power of laser tube be...