The laser won’t turn on
Release Time:2017/01/11 troubleshooting Browsing Times:1923
This problem is probably caused by one of three conditions:
1.Emergency Stop key is pressed in;
2.The fuse in power plug blew out or circuit breaker is off;
3.Defects of the Emergency Stop key or Main switch.
1.Make sure the Emergency Stop Switch is not pressed in.
2.
①Please check if the power plug just like the picture below, if yes, mare sure the circuit breaker in the back of the machine is not turned off.
②If your machine was bought before November 2016, please test if there ‘s 115V/230V power input by the following image or not? if there’s no 115V/230V power input, please check the fuse and replace it(see pic to find where’s the fuse).
3.If above are all normal, please test if there ‘s 115V/230V power input(Switch be off, test the sides of “O”) by the following image. If yes, the Emergency Stop key is fail; otherwise, the Main switch is fail.
- Laser cutter has a poor engraving quality/...
- My door is too narrow (only 80CM wide), ho...
- How to adjust the verticality between the ...
- How to calibrate the working table to level.
- Warning of LCD panel
- How to replace the motor and adjust the be...
- How to run several laser machines with one PC
- Why the Y axis cannot work suddenly?